24
PREPARATIONS
3 Slightly raise the control lever and remove the packing material from the underneath the
base in the direction of the arrow.
4 Wipe the sliding board with a cloth, etc. to remove dust.
5 Remove the styrofoam from the transportation bracket (A) (the one on the left hand side as
viewed from the chinrest side,), slide the base to the left and unscrew the transportation
bracket (B).
6 Slide the base to the right and unscrew the transportation bracket (A) with the screwdriver.
7 Fasten the rail covers, using the small screws that are attached.
8 Affix the chinrest tissue paper with the chinrest tissue pin.
Control lever
Sponge
Cushion
Styrofoam
Sponge
Sliding board
(between the instrument body and base unit)
Transportation bracket (A)
Transportation bracket (B)
Chinrest tissue pin
Chinrest tissue paper
To Next Page
Loading...
