23
PREPARATIONS
PREPARATIONS
ASSEMBLY PROCEDURE OF THE INSTRUMENT BODY
1 Take out the instrument body from the cardboard box and put it on the table.
Before transporting, ensure that the fixing knob has been adjusted to prevent back-and-
forth and right-and-left movement of the base. If the base moves, turn the fixing knob to
stop it.
When carrying the instrument body, firmly hold it at the following specified positions.
2 Loosen the fixing knob.
CAUTION
Before transporting this instrument, secure the fixing knob on the bot-
tom to prevent movements.
CAUTION
This instrument should be carried by two persons. Carrying by one
person may cause backache or injury. Holding at areas other than the
bottom may also cause injury, as well as falling, thereby damaging the
instrument.
CAUTION
To prevent damage and injuries, do not install the instrument on an
uneven, unsteady or sloping surface.
CAUTION
To avoid electric shock, unplug the power cord from the outlet before
assembling.
Do not plug the power cord into the outlet before assembling the
instrument.
NOTE
Since the upper part and lower part of the instrument body are merely
connected to each other with the power cable, take them out together
so they do not separate from each other.
NOTE
Always place the instrument in the center of the instrument table.
Holding positions
Fixing knob
Holding the instrument body
To Next Page
Loading...
