Toptech Systems MultiLoad II SCS User Manual

Chapter 13 – Custom Logic
369
Firmware Version 3/4.31.37
A PLEASE WAIT message displays momentarily while authorization takes place.
Then the Load Screen displays again.
On MultiLoad II On MultiLoad II SMP
(1/100 resolution is displayed when the Use Hundredths RCU W&M parameter is enabled)
Figure 12.1 Preset Control Screen
Low Sulfur Diesel
STOPPED
PRESET:
5000
DELIVER:
0
GALLONS
ExitLoad Clear=Preset Enter=Start
PRE PRODUCT SET DEL STATUS
>1 LS Diesel 5000 0 STOPPED
2 Preset 002 0 0 IDLE
Next Prev ExitLoad Enter=Pick
PRESET SCREEN
PRODUCT: Low Sulfur Diesel
PRESET QUANTITY: 5000
Please Wait…

Toptech Systems MultiLoad II SCS Specifications

General

Brand	Toptech Systems
Model	MultiLoad II SCS
Category	Control Unit
Language	English