Firmware Version 3/4.31.37
Select Remote Processing and press Enter. The ENABLED value changes to DISABLED, switching the
MultiLoad II to Local, standalone mode.
12.5.6 OPERATION IN LOCAL MODE
Operation in Local standalone mode is nearly identical to operation in Remote mode, with the following exception:
In Local mode the driver must key in product owner and customer IDs on the screen prompts (previously set up
with the Configuration tool). In other words, account picklists are not available in Local mode.
12.5.7 LOCAL AUTHORIZATION
As mentioned earlier, in Local mode, the MultiLoad II prompts the driver to insert a driver card or enter an access
ID/driver # and PIN. This PIN code must match the PIN code of the driver table stored in the MultiLoad II’s non-
volatile database. Once the PIN code is verified, the MultiLoad II acts upon an internal configuration regarding
additional prompts.
The MultiLoad II has up to four configurable prompts that may be displayed to the driver. Once data has been
entered for each of these prompts, MultiLoad II will authorize the load.
The configuration driver prompts are defined using the Miscellaneous function in the Configuration Tool. The
driver will view only those prompts defined. For example, if you defined Prompt 1 to prompt the driver for the
Shipper ID, the driver will be presented with the following screen.
To Next Page
Loading...
Need help?
General
