Firmware Version 3/4.31.37
In FCM2_TESTER build, added I/O board digital output, digital input, analog cal,
and analog test functions.
Updated FCM 2 Analog Tester to correctly exit RTD calibration mode.
Updated "4-20mA Input" to more descriptive "Observed 4-20mA".
Display yellow background on parameters changed from the default on RCU, Bay,
Preset, Component, Meter and Additive configuration screens.
Added "Id:X" to R912 W&M Log Register to include an Id with each W&M change
logged by TMS.
Updated R912 register to contain the ID of person that performed that change.
Updated View W&M log to have the ability to print a W&M log.
Added new terminal esc sequences for:
Added <esc>G command to set Foreground/Background text colors
Updated <esc>J and <esc>K to clear to EOL and EOS with color and size
attributes.
Added <esc>d command to Draw Customer Logo
Added <esc>e command to Draw Graphics Bitmap
Added <esc>g command to Fill Graphics Box with Color
Corrected API Table TEC-ETH to correctly apply TEC values. Was off by *10 on the
application of the TEC.
Corrected spelling of Component in the W&M change log.
Corrected TTE reported bug in Modbus 7000 register not resetting HOSTUP timer.
Corrected new bug that prevented printing tickets after a load.
Corrected new bug that caused line to not increment when printing details.
Corrected bug sending a UTF8 character instead of extended ASCII to the ticket
printer.
10/30/09 3.29.02 WJP
Corrected bug in ticket printing where line-feed character was not printing after
each line.
Corrected communications ports wrong factory default values.
Corrected bug in display type checking. Caused some legacy displays to dim too
much with the screen saver enabled.
Added ability auto detect display type and support QVGA.
SMP will default to QVGA for unknown displays.
ML will default to VGA for unknown displays.
Added identification of display id #0000 for legacy 8.4" displays.
Corrected bug that prevented alibi log printing on multidropped configurations.
11/02/09 3.29.02 WJP (released to QA)
11/11/09 3.29.02 WJP
Added card reader ability into SMP firmware, but defaults to disabled.
11/16/09 3.29.02 WJP
Added ability in view transaction archive details to display batches that have
the alarm flag set in red.
Added Batch_Alarm preset status bit (on MRS command) to latch any preset alarm to
be reported on transactions.
11/20/09 3.29.03 WJP
Updated SMP graphic to high resolution version.
To support adding back in card reader for SMP Div 2, also added back in Prox Card
Pull Secs and No Prox Pull If Flow parameters.
Corrected bug that prevented dual pulse output from working on port 2/3.
Updated preset, meter and component totalizers to accept and view volume in whole
units or hundredths.
Updated backflow totalizer logic to capture 100s without dropping precision
across whole numbers.
To Next Page
Loading...
Need help?
General
