Toro 31900A - Page 40

Main Menu (cont'd.)
S ETTINGS
Allows you to customize and
modify conguration variables
on the InfoCenter display .
Refer to the Settings ( page
40 ) table.
A BOUT Lists the model number , serial
number , and software version
of your machine. Refer to the
About ( page 40 ) table.
Service
Menu Item Description
H OURS
Lists the total number of hours
that the key , engine, and PT O
have been on.
C OUNTS Lists the number of engine
and PT O starts.
Settings
Menu Item Description
U NITS
Controls the units used on the
display screen. The menu
choices are English or metric.
L ANGUAGE
Controls the language used
on the display screen.
B ACKLIGHT
Controls the brightness of the
display screen.
C ONTRAST Controls the contrast of the
display screen.
P ROTECTED M ENUS Allows a person authorized
by your company with the
PIN code to access protected
menus (e.g., the slope sensor
setting).
P ROTECT S ETTINGS
When disabled, you can
access protected settings
without entering the PIN code.
T URNAROUND
Engages or disengages
T urnaround mode.
S LOPE S ENSOR I NSTALLED
Shows whether or not a
slope sensor is installed. If
a slope sensor is removed
from the machine, this setting
can be disabled to clear the
slope-sensor communication
fault.
Protected under Protected Menus—accessible only
by entering PIN
Diagnostics
Menu Item Description
D ECK
Indicates if the cutting unit
inputs/outputs are active.
Diagnostics (cont'd.)
PT O Indicates if the PT O is active.
E NGINE
Indicates if the engine
inputs/outputs are active.
About
Menu Item Description
M ODEL
Lists the model number of the
machine.
SN Lists the serial number of the
machine.
S/W R EV Lists the software revision of
the master controller .
Understanding the Display-Screen
Icons
Refer to the following table for a description of each
display-screen icon:
Display-Screen Icons
Engine speed
Engine fault
Hour meter
Air intake heater is active
Operator must sit in seat
Parking brake is engaged
Neutral
PT O is engaged
PT O is disabled
Indicates when the cutting units are
being lowered
Indicates when the cutting units are
being raised
PIN passcode
Battery
Coolant temperature
40