Multi Pro 1200/1250 Page 2 -- 1 Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of C ontents
PRODUCT RECORDS 1.........................
MAINTENANCE 1...............................
EQUIVALENTS AND CONVERSIONS 2...........
Decimal and Millimeter Equivalents 2............
U.S. to Metric Conversions 2...................
TORQUE SPECIFICATIONS 3....................
Fastener Identification 3.......................
Using a Torque Wrench with an Offset Wrench 3..
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Inch Series Fasteners) 4......
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Metric Fasteners) 5...........
Other Torque Specifications 6..................
Conversion Factors 6..........................
Product Records
Insert Operator’s Manual and Parts Catalog for your
MultiPro1200and1250attheendofthischapter.Refer
to Operator’s Manual for recommended maintenance
intervals. Additionally, insert Installation Instructions,
Operator’s Manuals and Parts Catalogs for any acces-
sories that have been installed on your Multi Pro at the
end of this chapter.
Maintenance
Maintenanceproceduresandrecommendedservicein-
tervalsfortheMultiPro1200andMultiPro1250arecov-
ered in the Operator’s Manual. R efer to that publication
whenperformingregularequipmentmaintenance.Sev-
eral maintenance procedures have break--in intervals
identified in the Operator’sManual. Refer to the Engine
Operator’s Manual for additional engine specific main-
tenance procedures.
Product Records
and Maintenance
To Next Page
Loading...
