Multi Pro 1200/1250Page 6 -- 54Spray System
Turret Bodies
1. Turret body (single LH barb)
2. Tee fitting (1 used per boom section)
3. Hose clamp
4. Turret body (double hose barb)
5. Turret body (single RH barb)
6. Hose
7. Hose
8. Hose
9. Flange nut
10. Mount bracket
11. Boom frame
12. Pop rivet (2 used per bracket)
Figure 59
RIGHT
BOOM
SUPPLY
CENTER
BOOM
SUPPLY
LEFT
BOOM
SUPPLY
5
4
4
4
1
1
4
4
1
5
5
2
3
6
8
9
10
1
5
7
4
3
3
11
12
FRONT
RIGHT
Removal (Fig. 59)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Loosen hose clamp(s) and remove supply hose(s)
from turret body.
3. Removeflangenutthatsecuresturretbodytomount
bracket. Remove turret body from machine.
Installation (Fig. 59)
NOTE: The type of hose barb on turret body deter-
mines turret location on spray boom. R efer to Figure59
for turret position on booms.
1. Positionturretbodyclamphalvestosprayboomand
turretbody.Slideclamphalvestogether.Levelturretand
tighten flange nut to secure turret body.
2. Install supply hose(s) to turret body. Tighten hose
clamp(s).
To Next Page
Loading...
