Toro Multi Pro 1200 - Front Brake Service

Multi Pro 1200/1250Chassis Page 8 -- 8
Front Brake Service
1. Flange head screw
2. Cap screw (2 used per wheel)
3. Flat washer (2 used per wheel)
4. Lock washer
5. Brake backing plate
6. Belleville washer
7. Dust cover
8. Adjuster lever
9. Wheel cylinder
10. Brake shoe
11. Upper spring
12. Lower spring
13. Shoe hold down cup and spring
Figure 5
7
6
10
8
9
1
4
5
2
3
12
11
13
6
8
10
13
110 to 120 in--lb
(12.4 to 13.6 N--m)
110 to 120 in--lb
(12.4 to 13.6 N--m)
Disassembly (Fig. 5)
1. Removefrontwheelandbrakehub/drumand,ifnec-
essary, remove brake assembly from machine (see
Front Wheels and Brakes in this section).
CAUTION
Be careful when removing springs from brake
shoes. The springs are under heavy tension and
may cause personal injury.
2. Remove upper and lower springs from brake shoes.
3. Remove shoe hold down cups and springs that se-
cure the brake shoes to the backing plate.
4. Remove brake s hoes from backing plate.
5. Ifbrakeassemblyisstillonmachineandwheelcylin-
der removal is necessary:
A. Clean hydraulic brake line areaofwheelcylinder
to prevent contamination.
B. Loosen and remove banjo bolt from wheel cylin-
derandbrakeline.Locateandretrievetwo(2)wash-
ersfrombrakelinefitting.Capbrakelineandposition
it away from brake assembly.
C. Remove two (2) flange head screws that secure
wheelcylindertobackingplate.Removewheelcylin-
der from backing plate.