Toro Multi Pro 1200 - Spray Control Assembly (Multi Pro 1250)

Multi Pro 1200/1250Page 6 -- 36Spray System
Spray Control Assembly (Multi Pro 1250)
1. Boom bypass hose
2. RH boom mount
3. LH boom mount
4. Cap screw (4 used)
5. Flange nut (4 used)
6. Hose clamp (3 used)
7. Agitation bypass hose
8. Flange nut (8 used)
9. LH boom supply hose
10. RH boom supply hose
11. Regulating valve assembly
12. Valve mount
13. Worm clamp (2 used)
14. Flange head screw (8 used)
15. Flowmeter assembly
16. Gasket (2 used)
17. Hose clamp
18. Tee controls hose
19. Boom valve manifold assembly
20. Flat washer (8 used)
21. Center boom supply hose
22. Coupler
23. Pressure gauge tube
Figure 39
FRONT
LEFT
2
3
6
9
10
11
13
1
5
7
12
14
15
16
17
18
19
20
4
17
17
16
13
8
21
22
23
NOTE: ARROWS SHOW FLUID
FLOW DIRECTION
IMPORTANT: The regulating valve and all boom
valve motors each havea5ampfuseforcircuit
protection. Make sure that the correct fuse is
installed in the in--line fuse holder located near the
spray control motors.