Multi Pro 1200/1250
Page 5 -- 24
Electrical System
Headlights
Headlight Removal (Fig. 39)
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from ignition
switch.
2. Reach beneath dash and push headlight out of the
hood.
3. Remove screws attaching the wire harness to the
headlight.
4. Remove rubber sealfromaround the headlight.Dis-
card headlight.
Headlight Installation (Fig. 39)
1. Alignnotchontheinsideofthesealwiththenotchon
thenewheadlight.Slidesealontothe headlightuntilthe
seal is firmly in place.
2. Attach headlight to the wire harness using the pre-
viously removed screws.
NOTE: Applying soapy water to the outside of the seal
will aid in sliding the seal into the hood. Make sure to
thoroughly dry headlights before turning lights on.
3. Align notch on the outside of the seal with the notch
in the hood. Push headlight and seal into the hood until
it is firmly in place.
1. Rubber seal
2. Outside notch
3. Headlight
Figure 39
2
1
3
To Next Page
Loading...
