EasyManua.ls Logo

Toro Multi Pro 1200 - Performance Verification and Setup; Application Rate Verification and Spray System Setup

Toro Multi Pro 1200
326 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Multi Pro 1200/1250
Page 5 -- 3
Electrical System
Special Tools
Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The multimeter can test electrical components and cir-
cuits for current, resistance or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt--
Ohm--Amp multimeter when testing electrical circuits.
Thehighimpedance(internalresistance)ofadigitalme-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Figure 1
Skin--Over Grease
Specialnon--conductive greasewhich formsa lightpro-
tective skin to help waterproof electrical switches and
contacts.
Toro Part Number: TOR50547
Figure 2
Dielectric Gel
Dielectric gel should be used to prevent corrosion of
connectionterminals.Toensurecompletec oatingofter-
minals, liberally apply gel to both component and wire
harness c onnector, plug connector to component, un-
plug connector, reapply gel to both surfaces and Con-
nect harness connector to component. Connectors
should be thoroughly packed with gel for effective re-
sults.
Toro Part Number: 107--0342
Figure 3
Electrical
System

Table of Contents

Other manuals for Toro Multi Pro 1200

Related product manuals