Toro Multi Pro 1200 - Turret Body Service

Multi Pro 1200/1250 Page 6 -- 55 Spray System
Turret Body Service
Disassembly (Fig. 60)
1. Pulle--clipfrombodyandslideplugw ithO--ringfrom
body.
2. Disassemble turretbody usingFigure60 asaguide.
3. Discardallremovedseals,gaskets,O--ringsanddia-
phragms.
Assembly (Fig. 60)
NOTE: CoatallO--ringswithvegetableoilbeforeinstal-
lationtoreducethechanceofdamageduringassembly.
1. Replaceallremovedseals,gaskets,O--rings anddi-
aphragms.
2. Assemble turret body using Figure 60 as a guide.
A. The turret (item 8) end with slightly larger bore
and detent grooves needs to be orientated toward
detent posts on body (item 4) (Fig. 61).
B. Make sure to align notch on plug (item 10) with
groove in body (item 4) as plug is installed.
C. Install e--clip (item 5) into body to secure assem-
bly.
1. Upper clamp
2. O--ring
3. Pivot pin
4. Body
5. E--clip
6. Gasket (3 used)
7. Dust cap (2 used)
8. Turret
9. O--ring
10. Plug
11. Nozzle
12. Nozzle cap
13. O--ring
14. Seal
15. Screw
16. End cap
17. Diaphragm
18. Hose barb
19. Cap screw
20. O--ring
Figure 60
2
1
3
6
4
5
11
10
12
14
13
15
8
7
9
17
16
18
6
19
20
1. Body
2. Detent post
3. Detent groove
Figure 61
3
2
1
2
Spray
System