Toro Multi Pro 1200 - Stub Axle and Driveshaft

Multi Pro 1200/1250Page 7 -- 24Drive Train
Stub Axle and Driveshaft
1. Lug nut (5 used per wheel)
2. Flange head screw
3. Wheel assembly
4. Brake drum
5. Stub axle
6. Lock washer (5 used per wheel)
7. Drive stud (5 used per wheel)
8. Cap screw (4 used per wheel)
9. Lock washer (4 used per wheel)
10. Brake assembly
11. Brake cable clip
12. Axle housing assembly
13. Flange head screw (3 used per wheel)
14. End yoke
15. Flat washer
16. Flange lock nut
17. Yoke strap (2 used per yoke)
18. Bolt (4 used per yoke)
19. Driveshaft assembly
20. Lock nut (2 used per driveshaft)
21. Cap screw (2 used per driveshaft)
22. Hardened washer (2 per driveshaft)
23. Parking brake cable
Figure 24
FRONT
RIGHT
Loctite #271
55 to 65 ft--lb
(75to88N--m)
220 to 225 ft--lb
(299 to 305 N--m)
Loctite #271
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
19
4
Loctite #271
200 to 250 in--lb
(22.6 to 28.2 N--m)
40 to 60 ft--lb
(55to81N--m)
20
21
22
23
Removal (Fig. 24)
1. Parkmachineonalevelsurface,stopengineandre-
move key from the ignition switch.
2. Chockfrontwheels.Raiserearwheelusingajackor
hoist (see Jacking Instructions in Chapter 1 -- Safety).
Support rear of machine with jack stands.
3. Loosen and remove lug nuts. Remove rear wheel.
Remove brake drum (see Rear Wheels and Brakes in
the Service and Repairs Section of Chapter 8 -- Chas-
sis).
NOTE: Looseningdriveshaftattransaxlewillalloweas-
ier driveshaft removal from end yoke.
4. Remove the straps securing driveshaft bearing
cross to the end yoke, then disconnect driveshaft from
the end yoke.
5. Loosenflangelocknutthatsecuresendyoketostub
axle. Remove flange lock nut, flat washer and flange
head screw. Pull end yoke from stub axle.
6. Carefully slide stub axle from axle housing.
7. To remove driveshaft from transaxle, loosen and re-
move lock nuts, cap screws and hardened washers se-
curingdriveshafttosplinedaxleshaftoftransaxle.Slide
driveshaft outward and remove from transaxle.