Toro Multi Pro 1200 - Boom Valve Manifold Assembly (Multi Pro 1250)

Multi Pro 1200/1250Page 6 -- 42Spray System
Boom Valve Manifold Assembly (Multi Pro 1250)
1. Boom valve motor (3 used)
2. Hose barb (boom supply) (3 used)
3. Pressure gauge port
4. Flange
5. Flynut
6. Elbow fitting (boom bypass)
7. Mounting bracket (2 used)
8. Balancing valve assembly
9. Flange
10. Fork (3 used)
11.Fork(6used)
12. O--ring (4 used)
13. O--ring (4 used)
14. O--ring (3 used)
15. Balancing valve assembly (2 used)
16. Washer (4 used)
17. Cap screw (4 used)
18. Lock nut (4 used)
19. Cap
Figure 47
2
3
6
8
9
10
11
13
1
5
7
12
14
15
16
17
18
4
1
1
16
12
12
12
18
7
11
13
NOTE: ARROWS SHOW FLUID
FLOW DIRECTION
19
TheMultiPro1250usesthree( 3) boomvalve motoras-
semblies to control the spray booms. Each boom valve
motorassemblyincludes amotor section and a balanc-
ing valve assembly.
The boom control switches on the operator spray con-
sole are used to energize the boom valve motors and
opentheboomvalves.Theopenboomvalvesallowsys-
tem flow to reach the appropriate boom section (right,
center or left).