Multi Pro 1200/1250 Page 6 -- 41 Spray System
Disassembly (Fig. 45)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Remove spray control assembly from machine and
separate regulating valve assembly from spray control
(seeSprayControlAssembly(MultiPro1250)Removal
in this section).
2. Disassemble regulating valve assembly as needed
usingFigure45asaguide.DiscardallremovedO--rings
and gaskets.
3. See Boom and Agitation Valve Motor Service in this
sectionfordisassemblyandassemblyinformationofthe
agitation valve motor.
Assembly (Fig. 45)
NOTE: CoatallO--ringswithvegetableoilbeforeinstal-
lationtoreducethechanceofdamageduringassembly.
1. Assemble regulating valve assembly using Figure
45 as a guide.
2. Attach regulating valve assembly to spray control
andtheninstallspraycontrolassemblyto machine(see
Spray Control Assembly (Multi Pro 1250) Installation in
this section).
1. Boom valve manifold
2. Flowmeter
3. Regulating valve
Figure 46
1
2
3
Spray
System
To Next Page
Loading...
