Multi Pro 1200/1250 Page 6 -- 43 Spray System
Disassembly (Fig. 47)
IMPORTANT: Make sure to remove and neutralize
chemicals from spray components before disas-
sembly. Wear protective clothing, chemical resist-
ant gloves and eye protection during repair.
1. Remove spray control assembly from machine and
separate boom valve manifold assembly from spray
control (see Spray Control Assembly (Multi Pro 1250)
Removal in this section).
2. Disassemble boom valve manifold assembly as
neededusingFigure47asaguide.Discardallremoved
O--rings and gaskets.
3. See Boom and Agitation Valve Motor Service in this
sectionfordisassemblyandassemblyinformationofthe
agitation valve motor.
Assembly (Fig. 47)
NOTE: CoatallO--ringswithvegetableoilbeforeinstal-
lationtoreducethechanceofdamageduringassembly.
1. AssembleboomvalvemanifoldassemblyusingFig-
ure 47 as a guide.
2. Attach boom valve manifold assembly to spray con-
trol and then install spray control assembly to machine
(see Spray C ontrol Assembly (Multi Pro 1250) Installa-
tion in this section).
1. Regulating valve
2. Flowmeter
3. LH boom valve motor
4. Center boom valve motor
5. RH boom valve motor
Figure 48
5
2
1
3
4
Spray
System
To Next Page
Loading...
