Multi Pro 1200/1250 Page 6 -- 23 Spray System
Disassembly (Fig. 20)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and other components before
disassembly.Wearprotectiveclothing,chemicalre-
sistant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Drain spray tank (see Operator’s Manual).
3. Label hoses to allow proper installation after repairs
arecompleted.Loosenhoseclampsandremovehoses
from all hosebarbs that are to be disassembled.
4. Remove agitation components as required using
Figure 20 as a guide. Discard all removed O--rings and
gaskets.
Assembly (Fig. 20)
NOTE: CoatallO--ringswithvegetableoilbeforeinstal-
lationtoreducethechanceofdamageduringassembly.
1. Install agitation components using Figure 20 as a
guide. Replace all removed O--rings and gaskets.
2. Using labels placed during disassembly, install
hoses to hosebarbs and secure with hose clamps.
3. Check spray system for leaks. Repair all leaks be-
fore returning the sprayer to service.
Spray
System
To Next Page
Loading...
