Toro Multi Pro 1200 - Page 149

Multi Pro 1200/1250 Page 6 -- 49 Spray System
NOTE: If suction tube in tank develops an air leak,
spray performance will diminish when tank level reach-
es the leak point.
Removal (Fig. 52)
IMPORTANT: Make sure to remove and neutralize
chemicals from tank and spray components before
disassembly.Wearprotectiveclothing,chemicalre-
sistant gloves and eye protection during repair.
1. Park machine on a level surface, stop engine, en-
gage parking brake and remove key from the ignition
switch.
2. Label hoses to allow proper installation after repairs
arecompleted.Loosenhoseclampsandremovehoses
from hosebarbs that are to be disassembled.
3. Remove suctionstrainerfromspray tank (seeOper-
ator’s Manual).
4. Raisetanklidandremovestrainerbaskettogainac-
cess to suction tube inside spray tank.
5. Remove suction tube assembly from spray tank us-
ing Figure 52 as a guide. Discard all removed O--rings
and gaskets.
6. For assembly purposes, measure andrecordlength
ofsuctiontubefromfilterhousingflangetofoot(Fig.54).
7. Disassemble suction tube as needed using Figure
53 as a guide.
Installation (Fig. 52)
NOTE: CoatallO--ringswithvegetableoilbeforeinstal-
lationtoreducethechanceofdamageduringassembly.
1. Assemble suctiontubeassemblyusingFigure53as
a guide. Make sure that assembled length is the same
as the length measured before disassembly (Fig. 54).
2. Install suction tube assembly into spray tank using
Figure52 as a guide. Replace all removed O--rings and
gaskets.The footof thesuctiontube footshould be less
than1/2inch(12.7mm)fromfloorofspraytankafteras-
sembly.
3. Using labels placed during disassembly, install
hoses to hosebarbs and secure with hose clamps.
4. Check spray tank for leaks. Repair all leaks before
returning the sprayer to service.
1. Hosebarb
2. O--ring (2 used)
3. Screen vane
4. Filter
5. Fork
6. Filter housing
7. Expansion pin (2 used)
8. Bulkhead gasket
9. Bulkhead nut
10. Hosebarb
11. Hose clamp (2 used)
12. Suction hose
13. Suction tube
14. Screw
15. Foot
Figure 53
2
3
6
8
9
10
11
13
1
5
7
12
14
15
4
2
Figure 54
MEASURE AND RECORD LENGTH
Spray
System