Multi Pro 1200/1250Page 7 -- 26Drive Train
5. Apply antiseize lubricant to splines of stub axle.
6. Slide end yoke onto stub axle shaft.
7. Insert cap screw through flat washer, end yoke and
stub axle. Install flange nut onto cap screw. Torque
flange nut from 220 to 225 ft--lb (299 to 305 N--m).
8. Position driveshaft cross to the end yoke. Install the
straps to secure driveshaft bearing cross to the end
yoke. Torque bolts from 200 to 250 in--lb (22.6 to 28.2
N--m).
9. Lubricate driveshaft grease fittings.
10.Install brake drum and wheel. Tighten wheel nuts to
a torque of 55 to 65 ft--lb (75 to 88 N--m) (see Rear
Wheels and Brakes in the Service and Repairs Section
of Chapter 8 -- Chassis).
11.Lower machine to ground.
To Next Page
Loading...
