Toro Multi Pro 1200 - Page 208

Multi Pro 1200/1250Page 7 -- 46Drive Train
5. Assemble 1st--reverse and 2nd --3rd fork shaft:
A. Insert 1st--reverse fork shaft (item 3) into 1st--re-
verse fork (item 2).
B. Drive spring pin (item 1) into fork and fork shaft.
Pay attention to direction of slit in spring pin.
C. Insert 2nd--3rd fork shaft (item 6) into 2nd--3rd
fork (item 5).
D. Drive spring pin (item 4) into fork and fork shaft.
Pay attention to direction of slit in spring pin.
2
1
3
6
4
5
Figure 74
6. Assemble countershaft:
A. Use a press to install two (2) new bearings (item
8) onto countershaft.
B. Install collar (item 4) and retaining ring (item 6).
C. Install countershaft gear (item 3) onto shaft.
D. Install r etaining ring (item 5).
E. Slide collar (item 2) onto shaft.
F. Use a press to install new bearing (item 1).
8
7
5
6
4
3
2
1
Figure 75