Multi Pro 1200/1250Page 7 -- 58Drive Train
27.Apply multi--purpose grease to P.T.O. cover O--ring
andinsertO--ringintogrooveoftransaxlecase.Position
P.T.O. cover (item 5) to transaxle case. Install five (5)
cap screws (item 4) and nut with lock washer (item 3).
Tightencapscrews and nut to a torque of 11 to 13 ft--lb
(15to17N--m).
28.If removed, install oil cap ( item 2) with O--ring to
transaxle case.
29.If removed, apply sealing tape to threads of air
breather (item 1) and install air breather.
11 to 13 ft--lb
(15to17N--m)
2
1
3
4
5
Figure 106
30.Apply silicone sealant to mating surface of upper
cover ( item 4). Pay attention to direction of cover and
install. Torque cap screws (item 3) from 18 to 22 ft--lb
(24.5 to 29.5 N--m).
31.If removed, slide speed sensor (item 2) into upper
cover(item4).Installcapscrew(item1)withlockwash-
er to secure sensor.
Figure 107
18 to 22 ft--lb
(24.5 to 29.5 N--m)
2
1
3
4
32.Position input shaft cover plate (item 2) to transaxle
and secure it with three (3) cap screws (item 1).
Figure 108
2
1
1
To Next Page
Loading...
