30
The S-4 Sculpting Sampler - Ofcial Manual
31
The S-4 Sculpting Sampler - Ofcial Manual
NOTES
Projects & Tracks
2
Projects & Tracks
2
NOTES
When working with external audio into tracks, the source conguration will
be required to select the input. This is accessible within the [CONFIG]
options within the track.
▌ CONFIGURING EXTERNAL STEREO / MONO AUDIO
1. Press [CONFIG] and navigate to the track to edit with the arrow action
buttons or Turn (SELECT). The Mono/Stereo setting is edited per track.
2. Press [OPEN] to select the track options. This presents the Track Input
and MIDI Channel options for the track.
3. Navigate to ‘TRACK INPUT’ and press [SELECT] or Turn one of the 8
Parameter knobs to change.
4. The option to set Stereo or Mono for the external audio in is available.
5. Note that there is also a ‘Sends Only’ option available in the track input
selection. Setting the track input to ‘Sends Only’ will only use the audio
that is set to send from other tracks and essentially ignore the line and
mic inputs.
▌ CONFIGURING THE EXTERNAL AUDIO SOURCE
1. The external audio input source can also be selected in the [CONFIG]
settings where the ‘AUDIO’ sub menu allows selection of the Line, Mic
or Headset audio inputs.
2. Turn (SELECT) to navigate to select the ‘AUDIO’ option. Also press the
[DOWN], or [UP], Action buttons to navigate the menu.
3. Press [OPEN], or Press (SELECT) to open the audio sub-menu.
4. Navigate to highlight the ‘INPUT MODE’ option.
5. Turn any of the 8 parameter knobs to adjust the setting. Alternatively,
Press [OPEN] to cycle the available options.
• LINE: Audio Line Inputs In 1 / In 2.
• MIC. Microphone. Front panel access to mic. Select This Option
• HEADSET. Connected TRRS headset microphone.
6. The microphone audio input gain can also be adjusted. Navigate to
highlight the ‘MIC GAIN’ option and Turn any of the 8 parameter knobs
to adjust the setting.
To Next Page
Loading...