138
9.10.5.2 MULT WRITE
・ OFF
・ ON
Notes:
1. It has a function which reduces the time to write data on the RFID chips. This is called “Multi-word write”.
Use of this function enables a speed-up of the data write operation. However, this function can not be
used except for chips that support writing in 32-bit units.
2. The following modules do not support this function.
B-EX6T1/T3
▪ B-EX706-RFID-U4-R
▪ B-EX706-RFID-U4-EU/US/AU-R
B-EX4T1
▪ B-EX700-RFID-U4-R
▪ B-EX700-RFID-U4-EU/US/AU-R
▪ U4 module preinstall model
9.10.6 CARRIER SENSE
The printer enters the carrier sense mode, and performs a carrier sense. Environmental radio wave of each
channel is picked up for about 30 times during 5 seconds.
The menu structure of CARRIER SENSE
Display example
Notes:
1. The following modules support this function.
B-EX6T1/T3
B-EX706-RFID-U4-R.
B-EX4T1
B-EX700-RFID-U4-R.
2. The left-most number indicates a channel number. The percentage means the availability of the channel,
which is determined by performing approx. 30 carrier senses. Thus, “100%” means that any other devices
do not use this channel.
3. The MAX column shows the value of the maximum radio wave picked up. The larger the value is, the
stronger radio wave source exists nearby.
4. The display can be scrolled up or down, from Channel 1 (1CH) to channel 9 (9CH), by using the [UP] or
[DOWN] key.
5. Pressing the [ENTER] key causes the printer to perform a carrier sense again. To exit a carrier sense,
press the [CANCEL] key.
To Next Page
Loading...
Need help?
General
