140
9.12 USB MEMORY
Contents of USB MEMORY menu
Notes:
1. The following table shows the error messages and descriptions which may be displayed while USB memory
is used:
After the error message is displayed, the operation is not retried.
FORMAT ERROR
Check the settings.
Format error or no memory installed
MEMORY WRITE ERR.
Check the data
and the settings.
MEMORY READ ERR.
Check the data
and the settings.
MEMORY FULL
Free some memory
space.
FILE NOT FOUND
Check the data
and the settings.
2. Depending on the remaining memory size or the USB memory status, a write error may occur even in the
case of insufficient free space.
3. Usable USB memory’s file system is as follows. To use other file system in USB memory, they need to be
formatted to either of the following on the PC in advance.
9.12.1 USB TO PRINTER
・ COPIED DATA
・ CONFIG FILE
Notes:
1. The data store in USB memory is copied to the printer.
COPIED DATA File (*.DAT) containing firmware (BOOT/MAIN/CG/KANJI/HTML), storage area
data, and parameter settings
The file is created in binary format when “PRINTER TO USB” is executed.
CONFIG FILE File (*.CFG) in which the path of the firmware (BOOT/MAIN/CG/KANJI/HTML) is
saved
The file is created in text format when the master media is made. The format of
the file is described in Section 12.Auto Configuration Mode.
2. When an item to be saved is selected, the file selection screen is shown.
3. For the file selection screen, see Section 7.6 FILE SELECTION .
* The scrollbar on the file selection screen is not provided with the knob regardless of the number of
files.
4. The confirmation display appears when a file is selected from the file selection screen.
To Next Page
Loading...
Need help?
General
