7
4.3 SYSTEM MODE
This mode is mainly used by service persons or the production department staff for adjustment of the printer
before shipment. The system mode contains the menus which might be changed not so frequently.
In addition to the parameter setting and fine adjustment menus common to the User System Mode, there
are sensor adjustment, interface, RFID, RTC and BASIC setting menus.
Furthermore, self-diagnosis, test print, RAM clear to initialize the printer settings, pre-shipment adjustment
for factory use, and the menu which enables saving parameter settings, external characters, TPCL
commands to the external USB memory or copying the data from the USB memory to the printer are
provided. The values set in this mode are stored in the non-volatile memory.
4.4 DOWNLOAD MODE
This mode is used to download boot and main programs firmware.
4.5 AUTO CONFIGURATION MODE
In this mode, the printer firmware is automatically updated with the program stored in a USB memory.
To Next Page
Loading...
Need help?
General
