Toshiba B-EX6T Series - 9.5.28 RIBBON TORQUE SETTINGS; 9.5.29 FRONT RIBBON MOTOR ADJUSTMENT

95
value exceeds the print head rating, it is automatically corrected.
3. The factory default is +0step.
B-EX4T1
Max.
value
Min. value
Step
Display
Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+10
-20
1
Decimal
Exist
2
0
None
Step
Remarks:
1. Setting a value in the positive (+) direction, the print tone becomes darker. And, setting a value in the
negative (-) direction, the print tone becomes lighter.
+10 ← (Darker) ← 0 → (Lighter) → -20
2. The print tone fine adjustment value (thermal transfer) is the sum of the fine adjustment values set in the
system mode (by key operation) and set by command (from the PC). The max. value is -20 ~ +10. If the
value exceeds the print head rating, it is automatically corrected.
3. The factory default is +0step.
9.5.27 TONE ADJ. <D>
B-EX6T1/T3
Max.
value
Min. value
Step
Display
Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+20
-20
1
Decimal
Exist
2
0
None
Step
Remarks:
1. Setting a value in the positive (+) direction, the print tone becomes darker. And, setting a value in the
negative (-) direction, the print tone becomes lighter.
+20 ← (Darker) ← 0 → (Lighter) → -20
2. The print tone fine adjustment value (direct thermal) is the sum of the fine adjustment values set in the
system mode (by key operation) and set by command (from the PC). The max. value is -20 ~ +20. If the
value exceeds the print head rating, it is automatically corrected.
3. The factory default is +0.
B-EX4T
Max.
value
Min. value
Step
Display
Sign
Integer
digit
Decimal
place
0-padding
Unit of
measure
+10
-20
1
Decimal
Exist
2
0
None
Step
Remarks:
1. Setting a value in the positive (+) direction, the print tone becomes darker. And, setting a value in the
negative (-) direction, the print tone becomes lighter.
+10 ← (Darker) ← 0 → (Lighter) → -20
2. The print tone fine adjustment value (direct thermal) is the sum of the fine adjustment values set in the
system mode (by key operation) and set by command (from the PC). The max. value is -20 ~ +10. If the
value exceeds the print head rating, it is automatically corrected.
3. The factory default is +0.