75
9.4.2 AUTO DIAGNOSTIC
The procedure for printing the self-diagnosis result is the same as that for the maintenance counter/parameter
setting data described in 9.4.1 MAINTENANCE COUNTER.
The following table shows the menu structure from top menu of the system mode to AUTO DIAGNOSTIC.
The menu structure of AUTO DIAGNOSTIC
Note:
When an error occurs while printing, the error message is displayed, the ERROR LED turns on, and the
ONLINE LED turns off. Though the error can be cleared by pressing the [ENTER], [CANCEL] or [MODE] key,
the printer does not reprint the label automatically.
9.4.2.1 AUTO SELF-DIAGNOSIS PRINTOUT
B-EX6T1/T3
Note:
“°” (degree) of “xx°C” may not be printed correctly,
depend on the type of code page.
PROGRAM B-EX6T1-T
MODEL B-EX6T1-TS18-CN-R
PRINTER S/N 2317A232688
MAIN XXXXXXXXX V1.0 :F100
BOOT XXXXXXXXX V1.0B :0000
XML XXXXXXXXX V1.0 :6700
WLAN XXXXXXXXX V1.0A :4300
FONT AE00
ZFONT 7600
KANJI GOTHIC :C300
MINCHO :1F00
CHINESE :F700
EEPROM 256B
SDRAM 32MB
SENSOR1 00000000,00000111
SENSOR2 [H]23ﾟC [A]22ﾟC
[R]4.2V [T]2.5V [E]0.6V
PE LV. [R]1.8V [T]2.5V
M THRE. [R]1.8V [T]2.5V
HEAD [RANK]7 305DPI
LAN MAC 11-22-33-44-55-66
EXP.I/O NG
EX.232C NG
SIO NG(0111)
RFID OK #00RV972 (EU0) R01
WLAN OK Ver1.1.3
MAC 00-11-22-33-44-55
RTC NG
USB MEMORY NG
BASIC M Z-EX4T1—M13 V1.3:02DC
BASIC S Z-EX4T1—S11 V1.1:BF1E
To Next Page
Loading...
