Toshiba B-EX6T Series - Set Parameters; Media Load

78
9.5 SET PARAMETERS
Contents of the SET PARAMETERS menu
Menu item
<2>SET PARAMETERS
MEDIA LOAD
FEED KEY
MOVE TO TEAROFF
FW/BK ACT.
RIBBON SAVE
HEAD UP CUT/RWD
PRE PEEL OFF
BACK FEED SPEED
AUTO HEAD CHECK
RIBBON NEAR END
PAPER/RBN END
CALIBRATE
POWER SAVE TIME
CODE PAGE
ZERO FONT
CTRL CODE
PEEL OFF STATUS
KANJI CODE
EURO CODE
MAXICODE SPEC
FEED ADJ.
CUT ADJ.
BACK ADJ.
X ADJUST
HEAT ENERGY TYPE
TONE ADJ.<T>
TONE ADJ.<D>
RIBBON TORQUE
FRONT RIBBON MOTOR
REAR RIBBON MOTOR
RIBBON WINDING
9.5.1 MEDIA LOAD
・ OFF Media loading function is disabled. (Same as a feed by press the [FEED] key)
・ STD When the [FEED] key is pressed after the printer is turned on, reset by a batch reset
command, or the print head is closed, the printer feeds the media to detect the next
gap/black mark. When the gap/black mark is detected, the printer feeds the media for
the distance from the sensor to the print start position.
・ ECO When the [FEED] key is pressed after the printer is reset by a batch reset command or
the print head is closed, the printer feeds the media to detect the next gap/black mark.
When the gap/black mark is detected, the printer feeds the media, which is positioned
nearest from the print head, to the print start position. At this time, the feed length is
calculated based on the stored media pitch.