Toshiba B-EX6T Series User Manual

30
6.10 LCD MESSAGES AND LED INDICATIONS
No
LCD Message
2
nd
line
(English)
LED
indications
Printer status
Restoration by
the [RESTART]
key
Yes/No
Acceptance of
Status Request
and Reset
Command
Yes/No
ON
LINE
ERROR
1
ONLINE

●
In the online mode
---
Yes

●
In the online mode
(Communicating)
---
Yes


In the online mode with a ribbon
near end detected (Note 1)
---
Yes
2
HEAD OPEN
●
●
A feed or an issue was attempted
with the head opened.
---
Yes
●

A feed or an issue was attempted
with the head opened in a ribbon
near end state. (Note 1)
---
Yes
3
PAUSE
●
●
In a pause state
Yes
Yes
●

In a pause state with a ribbon near
end detected (Note 3)
Yes
Yes
4
COMMS ERROR
●

A parity error or framing error has
occurred during communication by
RS-232C.
Yes
Yes
5
PAPER JAM
●

▪ A paper jam occurred during
paper feed.
▪ The media is not set properly.
▪ The media actually used and the
selected media sensor type do not
match.
▪ The media sensor position does
not align with the black mark
position.
▪ The actual media size and the
specified media length do not
match.
▪ The media sensor level is not
suitable for the actual media.
▪ The gap of pre-printed label
cannot be detected.
Yes
Yes
6
CUTTER ERROR
●

▪ A paper jam occurred in the
cutter.
▪ The cutter did not move from the
home position.
▪ The cutter cover was open.
Yes
Yes
7
NO PAPER
●

▪ The media has run out.
▪ The media has not been set.
▪ Media sensor level is not suitable
for the paper used.
Yes
Yes
8
NO RIBBON
●

The ribbon has run out.
Yes
Yes
9
HEAD OPEN
●

A feed or an issue was attempted
with the head opened.
(Except media feed caused by the
[FEED] key or Expansion I/O)
Yes
Yes
10
HEAD ERROR
●

▪ A broken dot error has occurred in
the thermal head.
▪ The error has occurred in the
head driver.
Yes
Yes
11
EXCESS HEAD
TEMP
●

The thermal head temperature has
become excessively high.
No
Yes

Toshiba B-EX6T Series Specifications

General

Brand	Toshiba
Model	B-EX6T Series
Category	Barcode Reader
Language	English