31
▪ An abnormal condition occurred
with the sensor for determining the
torque of the ribbon motor.
▪ A ribbon jam occurred.
▪ The ribbon has been torn.
▪ The ribbon has not been set.
An overflow error has occurred in
the rewinder unit.
SAVING ####KB/&&&&KB
or
SAVING %,%%%.%%%KB
External characters or PC
command save mode.
FORMAT ####KB/&&&&KB
or
FORMAT %,%%%.%%%KB
Initializing the storage area.
Downloading TrueType font or
BASIC program
An error has occurred while writing
data into the memory for storage.
(USB memory, flash ROM on the
CPU board)
An erase error has occurred while
formatting the memory for storage
(USB memory, flash Rom on the
CPU board)
Saving failed because of the
insufficient capacity of the memory
for storage (USB memory, flash
ROM on the CPU board)
SYNTAX ERROR
Command error
(Refer to Notes 1 and 2)
A command error has occurred
while analyzing the command.
A momentary power interruption
has occurred. (The LCD message
may corrupt before the error
message is displayed.)
A backup EEPROM cannot be
read/write pr.
When any abnormal operations as
below are performed, a system error
occurs.
(a) Command fetch from an odd
address
(b) Access to the word data from a
place other than the boundary of
the word data
(c) Access to the long word data from
a place other than the boundary of
the long word data
(d) Access to the area of 80000000H
to FFFFFFFFH in the logic space
in the user system mode.
(e) Undefined command placed in
other than the delay slot has been
decoded.
(f) Undefined command in the delay
slot has been decoded.
(g) Command to rewrite the delay
slot has been decoded.