Toshiba B-EX6T Series - Page 20

19
Threshold Setting Operation Example
1. Online mode:
Online state
B-EX4T1 C1.6
PRINTED 000000
IP:192.168.010.020
ONLINE
↓ Press the [PAUSE] key.
2. Online mode:
Pause state
PAUSE
↓ Hold down the [PAUSE] key for 3 seconds.
3. Threshold setting:
Media sensor selection
SELECT MEDIA SENSOR
▴ 1）REFL.(PRE-PRINT)
2）TRANS.(PRE-PRINT)
▾
Move the cursor with the [UP] or
[DOWN] key.
[CANCEL] key  “2. Pause state.” (Threshold setting end.).
“[FEED] + [RESTART]” key is invalid in this state.
↓ Press the [ENTER] key.
4. Threshold setting:
Waiting for the media to be
loaded
1）REFL.(PRE-PRINT)
THRESHOLD MODE
▴ Load the media.
Press the PAUSE Key
▾ to start the
Scroll the screen with the [UP] or
[DOWN] key.
[CANCEL] key  “2. Pause state.” (Threshold setting end.).
“[FEED] + [RESTART]” key is invalid in .
↓ Press the [PAUSE] key.
5. Threshold setting:
Calibration
1）REFL.(PRE-PRINT)
THRESHOLD MODE
Calibrating
Hold down the [PAUSE] key to keep
feeding the media.
↓ Release the [PAUSE] key. (Media feed stops.)
When the judgment result is OK, go to “6. Threshold setting”.
When the judgment result is NG, go to “7. Threshold setting”.
6. Threshold setting:
6a. Judgment result: OK
(After threshold setting)
1）REFL.(PRE-PRINT)
Result: OK (Mid.)
Threshol
Baseline
Retry FEED
Detail▶
[FEED] key  “3. Media sensor selection.” (Threshold is set again.)
[ENTER] key  “2. Pause state.” (Threshold setting is completed.)
[RIGHT] key  “6b. Details of the result.” (Result and the threshold value are displayed.)
6b. Details of the result
1）REFL.(PRE-PRINT)
Peak : 3.7V
Threshold
: 2.7V
Baseline : 1.3V
◀Result
Adjust▶
↓ Press the [RIGHT] key.