- 9 -
< 2 > P A R A M E T E R S E T
P A R I T Y E V E N
< 2 > P A R A M E T E R S E T
X O N + R E A D Y A U T O
< 2 > P A R A M E T E R S E T
L C D E N G L I S H
< 2 > P A R A M E T E R S E T
F O R W A R D W A I T O F F
< 2 > P A R A M E T E R S E T
F W / B K A C T . M O D E 1
< 2 > P A R A M E T E R S E T
H U C U T / R W D . O F F
< 2 > P A R A M E T E R S E T
S O L E N O I D T Y P E 2
< 2 > P A R A M E T E R S E T
R B N S A V E O N ( T A G )
[PAUSE]
(33) Ribbon saving system setting:
Determine whether or not the ribbon
saving system is used with the [FEED]
and [RESTART] keys.
[PAUSE]
[PAUSE]
[PAUSE]
(19) Parity selection:
Select the parity using the [FEED] and
[RESTART] keys.
(23) Language selection for LCD messages:
Select the language for LCD messages
using the [FEED] and [RESTART] keys.
(21) Transmission control method selection:
Select the transmission control method
using the [FEED] and [RESTART] keys.
(22) Press the [PAUSE] key.
(20) Press the [PAUSE] key.
[PAUSE]
(24) Press the [PAUSE] key.
(25) Setting for forward feed standby in cut
issue mode:
Make the forward feed standby setting
using the [FEED] and [RESTART] keys.
(29) Setting for head-up operation in cut
issue mode, or for using the rewinder in
batch issue mode:
Make the head-up operation setting/the
rewinder use setting using the [FEED]
and [RESTART] keys.
(34) Press the [PAUSE] key.
(26) Press the [PAUSE] key.
(30) Press the [PAUSE] key.
[PAUSE]
[PAUSE]
(31) Installed solenoid type setting: Set
which type of solenoid is installed,
TYPE 1 or TYPE 2 with the [FEED] and
[RESTART] keys.
(32) Press the [PAUSE] key.
[PAUSE]
(27) Setting for forward feed standby action:
When the forward feed standby is set to
ON, select the action of the forward feed
standby using the [FEED] and
[RESTART] keys.
(28) Press the [PAUSE] key.
To Next Page
Loading...
