4 Replacement Procedures 4.7 Keyboard
4-22 [CONFIDENTIAL] QOSMIO G30 Maintenance Manual (960-546)
Installing the keyboard
The following describes the procedure for installing the keyboard (See Figure 4-10 to 4-11).
1. Place the keyboard on the palm rest with its face down. Connect the keyboard cable
to the connector CN3200 on the system board.
2. Install the keyboard support plate and secure it with the following screws.
• M2.5×8B FLAT BIND screw ×1
3. Turn the keyboard face up and put it on the computer. Make sure that there is no
space between the keyboard and the computer.
4. Secure the keyboard with the following screws.
• M2.5×4B FLAT BIND screw ×2
5. Install the keyboard holder (the topside first) and press it to latch.
To Next Page
Loading...
Need help?
General