4 Replacement Procedures 4.36 Fluorescent Lamp
4. Turn the BL unit (E) face down and install the reflection sheet (J) and light guide
plate (I).
CAUTION: Do not scratch or make dirty.
Insert the reflection sheet (J) in to the lamp unit (M) and place it at the
projection portion on the short side.
Insert slantingly the light guide plate (I) (not to deform the reflector). Stick
the thin side to the double-sided tape and secure it.
Outline of the section of lamp side
M/Reflector
M/Lamp
Light guide plate (I)
Figure 4-71 Replacing 17.1 Inch Sharp fluorescent lamp (12)
4-100 [CONFIDENTIAL] QOSMIO G30 Maintenance Manual (960-546)
To Next Page
Loading...
