4.36 Fluorescent Lamp 4 Replacement Procedures
2. Turn the BL unit (E) face down and install a new lamp unit (M).
CAUTION: Be careful not to deform the lamp unit (M).
Insert the lamp unit one by one at the exit (**) of lamp harness not to
damage the harness.
Figure 4-69 Replacing 17.1 Inch Sharp fluorescent lamp (10)
3. Install the new lamp cover (L) on the BL unit and secure them with two screws (K)
.
Insert the projection at the both sides of lamp cover.
The torque tightening the screw
shall be 0.1 N m
Hook the 3 latches on the bottom side of lamp cover.
Figure 4-70 Replacing 17.1 Inch Sharp fluorescent lamp (11)
QOSMIO G30 Maintenance Manual (960-546) [CONFIDENTIAL] 4-99
To Next Page
Loading...
