Introduction Connections Basic Setup Playback
Editing
VCR Functions Others
Function Setup
Recording
85
EN
5. Audio Out
Set the digital audio output.
(Follow steps 1 to 4 on page 83 as left.)
Select “Audio Out” using
[Cursor
U / D], then press [ENTER].
Menu window will appear.
Select a setting using
[Cursor
U / D], then press [ENTER].
Proceed with either of the following steps.
PCM (Default: 48kHz)
Select a setting using
[Cursor
L / P], then press [ENTER].
Your setting is activated.
48kHz: If your amplifier / decoder is NOT compatible
with 96 kHz PCM, select “48kHz”. Sound
recorded at 96 kHz is down sampled to
48 kHz.
96kHz: If your amplifier / decoder is compatible with
96 kHz PCM, select “96kHz”. Sound is
sampled at 96 kHz.
Note
When playing back disc with copyright protection:
• Even if you select “96kHz”, the sound will be down
sampled at 48 kHz.
Dolby Digital (Default: Stream)
Select a setting using
[Cursor
L / P], then press [ENTER].
Your setting is activated.
PCM: Converts the Dolby Digital into PCM
(2 channel).
If your amplifier / decoder is NOT compatible
with Dolby Digital, set to “PCM”.
Stream: Outputs Dolby Digital signals.
If your amplifier / decoder is compatible with
Dolby Digital, set to “Stream”.
Hint
When playing back a DVD-RW disc recorded in VR
mode:
• If the audio source on a disc is in Dolby Digital
format, set “Dolby Digital” to “PCM” so that you can
switch to main audio (L), sub audio (R), or a
combination of both (L / R) using your amplifier /
decoder.
MPEG (Default: PCM)
Select a setting using
[Cursor
L / P], then press [ENTER].
Your setting is activated.
PCM: Converts MPEG into PCM.
If your amplifier / decoder is NOT compatible
with MPEG, set to “PCM”.
Stream: Outputs MPEG Audio signals.
If your amplifier / decoder is compatible with
MPEG, set to “Stream”.
DTS (Default: On)
Select a setting using
[Cursor
L / P], then press [ENTER].
Your setting is activated.
On: Outputs DTS signals.
If your amplifier / decoder is compatible with
DTS, set to “On”.
Off: No DTS signal is output.
If your amplifier / decoder is NOT compatible
with DTS, set to “Off”.
Dynamic Range Control (Default: On)
Set to “On” to make the dynamic range narrower.
Select a setting using
[Cursor
L / P], then press [ENTER].
Your setting is activated.
The Dynamic Range Control function is effective
only with analogue audio connection.
Fast Forward with Audio (Default: Off)
Set to “On” to output the sound during DVD playback
at x1.5 fast forward.
Select a setting using
[Cursor
L / P], then press [ENTER].
Your setting is activated.
Audio Out
PCM
MPEG
DTS
Dynamic Range Control
Fast Forward with Audio
Dolby Digital
Dolby Digital
To Next Page
Loading...
