Toshiba STRATA CIX - Do Not Disturb

Voice Mail
Configuration
Voice Mail Configuration
Parameters
Strata CIX Voice Mail Programming 01/07 3-33
sys_box_idx Specifies the digits that a caller must dial to launch the directory application.
The auto attendant compares dialed digits with this pattern before
attempting to select a user agent for transfer.
Note Voice mail builds an index file based on information given in the
Directory Name fields. It enables you to use one or more letters to
perform the search, matching all entries possible. For every mailbox
number that matches, the Stratagy ES plays the name recording–
which really may play any recording you want, if available.
Possible values: any valid digits
Default: 411
sys_cancel_busy_hold Whether the system allows callers to hold for busy extensions.
Possible values:
True: Callers cannot hold for busy extensions.
Calls proceed as if a Ring No Answer.
False: (default) Callers can hold for busy extensions.
sys_cng_tone Fax “CNG” tone in line tone construction format, which is described below.
There are four kinds of tones: single frequency, single frequency with
cadence, dual frequency and dual frequency with cadence. Each tone
description consists of a comma separated by a list of numbers.
Possible values:
Single Frequency: ID, F1, F1Dev, Leading_Edge
Dual Frequency: ID, F1, F2, F1Dev, F2Dev, Leading_Edge
Single w/cadence: ID, F1, F1Dev, On, OnDev, Off, OffDev, Repeat
Dual w/cadence: ID, F1, F2, F1Dev, F2Dev, On, OnDev, Off, OffDev, Repeat
where: ID Fax Carrier Tone (this should be 103)
F1, F2 Frequencies in Hz
F1Dev, F2Dev Frequency deviations in Hz
On Time the tone must be present (ms)
Off Time the tone must be absent (ms)
OnDev Allowable deviation in the on time (ms)
OffDev Allowable deviation in the off time (ms)
Leading_Edge If 1, signals the presence of the tone at its
leading edge, If 0, at its trailing edge.
Repeat The number of on-off cycles that must occur
before signalling the presence of the tone.
Default: 113, 1100, 100, 500, 100, 3000, 100, 1
sys_company_fax_number This telephone number is used when sending faxes to identify the source of
the fax.
Note This parameter is not currently supported.
Default: blank comment line
sys_company_name The name that will appear in the fax header for sent faxes. This field is
limited to 32 characters.
Note This parameter is not currently supported.
Default: blank comment line
Table 3-12 Parameter Definitions (continued)
Parameter Description