Toshiba TOSVERT VF-nC3E

E6582233
H-9
8 8
 Output voltage: The voltage displayed is the output command voltage. 100% reference
value is 400V on 400V models.
This unit can be switched to V (volts).
 Torque current: The reference value (100% value) is the rated output current indicated on
the nameplate. The current required to generate torque is calculated from
the load current by vector operations. The value thus calculated is
displayed.
 Load factor of inverter: Depending on the PWM carrier frequency (f300) setting and so on, the
actual rated current may become smaller than the rated output current
indicated on the nameplate. With the actual rated current at that time (after
a reduction) as 100%, the proportion of the load current to the rated
current is indicated in percent. The load factor is also used to calculate the
conditions for overload trip (
).
Note 11: Status monitor of * mark is displayed by
 to  and  setting.
The left side character is as following table by each parameter setting number.
Paramete
r
Settin
g
No. LED displa
y
Function Unit
 to ,

0
x50.0
Operation frequenc
y
Hz / free uni
t
1
c16.5
Output curren
t
% /
A
2
f50.0
Frequenc
y
settin
g
value Hz / free uni
t
 to 
3
y100
Input volta
g
e
(
DC detection
)
% / V
4
p 90
Output volta
g
e
(
command value
)
% / V
5
k 3.0
Input powe
r
kW
6
h 2.8
Output powe
r
kW
7
q 80
Tor que %
8
w 90
Torque curren
t
% /
A
9-11 - - -
12
b40.0
Frequency setting value (after
compensation)
Hz / free unit
13-17 - - -
，
18 **** Arbitrar
y
code from communication -
 to 
19-22 - - -
23
d40.0
PID feedback value Hz / free uni
t
24-26 - - -
27
l 70
Drive load facto
r
%
 to ,

28-33 - - -
34
n89.0
Number of startin
g
10000 times
35-51 - - -
52
w50.0
During stop : Frequency setting value
Durin
g
operation : Operation frequenc
y
Hz / free unit