Chapter 4
Command Summary
The following table summarizes the available NetAudio commands. It also indicates
whether or not the NetAudio server should b e running and provides a cross reference
to the Section(s) in this manual where the command is described in detail.
Command Function Server Reference
naplay
Playback and transfer to tape Yes 5
narecord
Recording onto disk Yes 6
narecseg
Record and segment speech Yes 6.15
nastatus
Status monitoring Yes 10.2
naset
Parameter setting (gain, pause, etc.) Yes 10.3
xnaplay
Playbackofmultiple les Yes 10.6
nagetfilter
Acquisition of lter resp onses Yes 10.5
naloop
Loopback testing of DAT-Link Yes 2.7.3
naversion
Display hardware & software versions Yes 10.1
naloaddsp
Load user DSP programs Yes 10.4
rc
Remote control Yes 8
rctrain
Remote control training and testing No 8.1,2.7.2
sv3900
Remote control of SV-3900 Yes 8.3
dlmplay
Multi-channel playback No 9.3
dlmrec
Multi-channel recording No 9.2
dltest
Testing of DAT-Link No 2.7.1
naserver
NetAudio Server 3
netaudiod
NetAudio Daemon 3.1
To Next Page
Loading...