TP-Link T2600G-28TS - Page 195

183
The following entries are displayed on this screen:

Create Interface
Interface ID: Enter the ID of the interface corresponding to VLAN interface
,
loopback interface, routed port or port channel.
IP Address Mode: Specify IP Address allocation mode.
 None: without ip.
 Static: setup manually.
 DHCP: allocated through DHCP.
 BOOTP: allocated through BOOTP.
IP Address: Specify the IP address of the interface.
Subnet Mask: Specify the subnet mask of the interface's IP address.
Admin Status: Specify interface administrator status. Choose Disable to disable
the interface's Layer 3 capabilities.
Interface Name: Specify the name of the network interface.

Interface List
Select : Select the interfaces to modify or delete.
ID: Displays the ID of the interface.
Mode: Display IP address allocation mode.
 None: without ip.
 Static: setup manually.
 DHCP: allocated through DHCP.
 BOOTP: allocated through BOOTP.
IP Address: Displays the IP address of the interface.
Subnet Mask: Displays the subnet mask of the interface.
Interface Name: Displays the name of the interface.
Status: Displays interfa
ce current working status. Working status is up
when admin status is enabled
, line protocol is up and IP Address
is set.
Operation: You can configure the interface by clicking the Edit
, or check
Detail information by clicking Detail.