TP-Link T2600G-28TS - Page 196

184
 For IPv4 interface
Click Edit to display the following figure:
Figure 10-4 IPv4 Interface Config

Modify Interface
Interface ID:
Display the ID of the interface corresponding to the VLAN
interface, loopback interface, routed port or port channel.
IP Address Mode: View and modify the IP address allocation mode.
 None: without ip.
 Static: setup manually.
 DHCP: allocated through DHCP.
 BOOTP: allocated through BOOTP.
IP Address: View and modify the IP address of the interface.
Subnet Mask: View and modify the subnet mask of the interface.
Admin Status: View and modify the Admin status. Choose Disable
to disable
the interface's Layer 3 capabilities.
Interface Name: View and modify the interface name.

Secondary IP Create
IP Address: Specify the secondary IP address of the interface.
Subnet Mask: Specify the subnet mask of the interface's secondary IP address.

Secondary IP List
Select: Select the secondary IP.
IP Address: Displays the secondary IP address of the current interface.