TP-Link TL-SG5426 - Dynamic IP Source Guard Binding Information; Figure 3-120 Static IP Source Guard Binding Configuration

IP Source Guard
3-193
3
Command Attributes
• Static Binding Table Counts – The total number of static entries in the table.
• Port – Switch port number. (Range: 1-26)
• VLAN ID – ID of a configured VLAN (Range: 1-4094)
• MAC Address – A valid unicast MAC address.
• IP Address – A valid unicast IP address, including classful types A, B or C.
Web – Click IP Source Guard, Static Configuration.
Figure 3-120 Static IP Source Guard Binding Configuration
CLI – This example shows how to configure a static source-guard binding on port 5.
Dynamic IP Source Guard Binding Information
Displays the source-guard binding table for a selected interface.
Command Attributes
• Query by – Select an interface to display the source-guard binding. (Options: Port,
VLAN, MAC Address, or IP Address)
• Dynamic Binding Table Counts – Displays the number of IP addresses in the
source-guard binding table.
• Current Dynamic Binding Table – Displays the IP addresses in the source-guard
binding table.
Console(config)#ip source-guard binding 11-22-33-44-55-66 vlan 1
192.168.0.99 interface ethernet 1/5 4-229
Console(config)#