Command Line Interface
4-234
4
Related Commands
ip dhcp snooping (4-231)
ip dhcp snooping trust (4-234)
ip dhcp snooping trust
This command configures the specified interface as trusted. Use the no form to
restore the default setting.
Syntax
[no] ip dhcp snooping trust
Default Setting
All interfaces are untrusted
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• An untrusted interface is an interface that is configured to receive messages
from outside the network or firewall. A trusted interface is an interface that is
configured to receive only messages from within the network.
• When DHCP snooping enabled globally using the ip dhcp snooping
command (page 4-231), and enabled on a VLAN with this command, DHCP
packet filtering will be performed on any untrusted ports within the VLAN
according to the default status, or as specifically configured for an interface
with the no ip dhcp snooping trust command.
• When an untrusted port is changed to a trusted port, all the dynamic DHCP
snooping bindings associated with this port are removed.
• Additional considerations when the switch itself is a DHCP client – The port(s)
through which it submits a client request to the DHCP server must be
configured as trusted.
Example
This example sets port 5 to untrusted.
Related Commands
ip dhcp snooping (4-231)
ip dhcp snooping vlan (4-233)
Console(config)#interface ethernet 1/5
Console(config-if)#no ip dhcp snooping trust
Console(config-if)#
To Next Page
Loading...
Need help?
General