EasyManua.ls Logo

TP-Link TL-SG5426 - Configuring Snmpv3 Groups

TP-Link TL-SG5426
499 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Simple Network Management Protocol
3-41
3
CLI – Use the snmp-server user command to configure a new user name and
assign it to a group.
Configuring SNMPv3 Groups
An SNMPv3 group sets the access policy for its assigned users, restricting them to
specific read, write, and notify views. You can use the pre-defined default groups or
create new groups to map a set of SNMP users to SNMP views.
Command Attributes
Group Name – The name of the SNMP group to which the user is assigned.
(Range: 1-32 characters)
Model – The user security model; SNMP v1, v2c or v3.
Level – The security level used for the group:
- noAuthNoPriv – There is no authentication or encryption used in SNMP
communications. (This is the default for SNMPv3.)
- AuthNoPriv – SNMP communications use authentication, but the data is not
encrypted (only available for the SNMPv3 security model).
- AuthPriv SNMP communications use both authentication and encryption (only
available for the SNMPv3 security model).
Read View – The configured view for read access. (Range: 1-64 characters)
Write View – The configured view for write access. (Range: 1-64 characters)
Console(config)#snmp-server user mark group r&d remote 192.168.1.19 v3
auth md5 greenpeace priv des56 einstien
4-113
Console(config)#exit
Console#show snmp user
4-113
No user exist.
SNMP remote user
EngineId: 80000000030004e2b316c54321
User Name: mark
Authentication Protocol: none
Privacy Protocol: none
Storage Type: nonvolatile
Row Status: active
Console#

Table of Contents

Related product manuals