Command Line Interface
4-22
4
The ! command repeats commands from the Execution command history buffer
when you are in Normal Exec or Privileged Exec Mode, and commands from the
Configuration command history buffer when you are in any of the configuration
modes. In this example, the !2 command repeats the second command in the
Execution history buffer (config).
reload
This command restarts the system.
Note:
When the system is restarted, it will always run the Power-On Self-Test. It will also
retain all configuration information stored in non-volatile memory by the copy
running-config startup-config command.
Default Setting
None
Command Mode
Privileged Exec
Command Usage
This command resets the entire system.
Example
This example shows how to reset the switch:
end
This command returns to Privileged Exec mode.
Default Setting
None
Command Mode
Global Configuration, Interface Configuration, Line Configuration, and VLAN
Database Configuration.
Example
This example shows how to return to the Privileged Exec mode from the Interface
Configuration mode:
Console#!2
Console#config
Console(config)#
Console#reload
System will be restarted, continue <y/n>? y
Console(config-if)#end
Console#
To Next Page
Loading...
Need help?
General