Transonic HT331-FT - Page 6

vi AU-OPR-AureFloFT-EN,
Rev H
√ Always follow the correct shut off procedure see "After Measurements Are Completed" on page 30.
Appropriately exit FlowTrace
®
software before turning off power to the AureFlo
®
Monitor.
√ In the event of the loss of power during operation, a loss of data may occur when using continuous recording
mode.
√ Patient data downloaded from the AureFlo
®
must be handled in accordance with institutional and HIPPA
guidelines and in accordance with the patient condentiality requirements.
√ Do not connect the AureFlo
®
system to the internet during use with a patient.
√ The operator should not touch the cart or its components except for the applied parts (probes) and the patient
at the same time.
√ The AureFlo monitor has been congured to work with the AureFlo system, changes to the PC settings such
as adjusting screen resolution, enabling WiFi or installing additional programs can impact the functionality of
the AureFlo or cause a loss of patient data. Please consult with Transonic before making changes to the PC not
specied in the manual or Transonic support materials.
√ For a comprehensive list of possible warning symbols please refer to Appendix H: Symbols & Signs.
TRANSONIC
®
FLOWPROBES/FLOWSENSORS DO NOT CONTAIN LATEX MATERIALS.
Warnings & Precautions