Transonic HT331-FT - Upgrading Flowtrace Software

36 AU-OPR-AureFloFT-EN,
Rev H
4) FlowTrace
®
software will begin to load
automatically. When software installation is
complete, select [Finish] to close the installation
window.
5) Remove the FlowTrace
®
installation disk and store in
a safe place.
6) Set date and time via Windows (Fig. A.2). Restart
the Flowmeter after setting time to ensure it
properly updates.
C. Upgrading FlowTrace
®
Software
(FOR UPGRADING, UPDATING OR REINSTALLING
FLOWTRACE
®
SOFTWARE WHEN A VERSION IS ALREADY
INSTALLED)
1) Turn on AureFlo
®
system
2) Exit FlowTrace
®
software by pressing [System
Settings] and then pressing [Quit FlowTrace].
3) Insert FlowTrace
®
software installation CD into the
Monitor. FlowTrace
®
installation will auto-start.
4) Select the desired language and then select [OK] (Fig. A.1, page 35),
5) A warning indicating that FlowTrace
®
is already installed will appear (Fig. A.3). Select [OK] to continue
installation or [Cancel] to stop the installation and keep the current version.
6) A second screen conrming the decision to uninstall will appear (Fig. A.4). Select [Yes] to remove the
current version and then [OK] on the next screen, indicating a successful uninstall, to nish.
7) The installation window for the new version will then appear. Select [Next] to continue.
Fig. A.2: Update Date and Time screen
Initial AureFlo
®
Setup
Fig. A.3: FlowTrace
®
already installed warning screen
Fig. A.4: Uninstall current version conformation screen