Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide 107
Software Utilities 16
Trimble R6 GPS and R8 GNSS Receiver Operation
The Frequency Selection dialog appears:
6. In the Wireless Format group, select the appropriate channel and wireless mode.
The Wireless Mode must be the same for all radios in your network.
7. In the Specify Frequency field, enter the frequency you require.
8. Click
Add. The new frequency appears in the Selected Frequencies list.
Note – The frequencies that you program must conform to the channel spacing and
minimum tuning requirements for the radio. To view this information, click
Radio Info.
You may select either 12.5 or 25 kHz channel spacing. All radios in your network must use
the same channel spacing.
9. When you have configured all the frequencies you require, click
OK.
The WinFlash utility updates the receiver radio frequencies and then restarts
the receiver.
Note – You can only configure receive frequencies. The FCC approved transmit frequencies
must be specified and configured by Trimble.
To Next Page
Loading...
Need help?
General
