Trimble R6/R7 GPS and Trimble R8 GNSS Receivers User Guide 61
Default Settings 9
Trimble R7 GPS Receiver Operation
9.2 Resetting to factory defaults
To reset the receiver to its factory defaults, do one of the following:
• On the receiver, press and hold down [P] for 15 seconds.
• In the GPS Configurator software, select Connect to Receiver and then click Reset
receiver in the General tab.
9.3 Examples
The following examples show how the Trimble R7 GPS receiver uses the default
settings and special application files in various situations.
93.1 Default behavior
The factory defaults are applied whenever you start the receiver. If a power up file is
present in the receiver, its settings are applied immediately after the default settings, so
you can use a power up file to define your own set of defaults.
93.2 Power up settings
When you turn the receiver off, any changes that you have made to logging settings are
lost and these settings are returned to the factory defaults. Other settings remain as
defined in the current file. The next time you turn on the receiver, the receiver checks
for a power up file and, if one is present, applies the settings in this file.
When you turn the receiver
on and …
then logging settings
are …
and logging …
it is the first time that the
receiver has been used
the factory defaults does not begin
automatically
you have reset the receiver to its
factory defaults
the factory defaults, or
those in the power up file
a
a
A factory default setting is used only if the setting is not defined in the power up file.
does not begin
automatically
you have performed a full reset the factory defaults,
because resetting deletes
any power up file
does not begin
automatically
When you use [P] to turn
the receiver off then on
again and …
then logging settings
are …
and all other settings
are …
you changed the receiver
settings by applying an
application file
the factory defaults the last settings used
To Next Page
Loading...
Need help?
General
